GRAB RAIL ANCHOR BRACKET
INSTRUCTIONS
The Perfect Rail Grab Rail Anchor Bracket is design to ensure that the Grab Rail Anchors are aligned and installed plumb, level and secure. This bracket is mounted to the back side of the top panel flange.
​​​
-
Unpack the Box:
-Remove all contents from the box.​ -
Align the Face Bracket: - Position the face bracket on the top back panel flange. Level the face bracket and mark the hole location. Drill two (2) 3/8-inch holes on the back panel flange.
-
Bolt the Face Bracket:
- Attach the face bracket to the panel using two (2) 3/8-inch bolts and nuts, leaving them loose for adjustment. -
Install Adjustable Arm:
- Attach the adjustable arm to the face bracket. Leave loose for adjustment. -
Secure Anchors:
- Attach two (2) anchors to the adjustable arm. Adjust the anchors to desired position. Tighten nuts. -
Set Anchor Height: - LEVEL across anchors and coping and tighten face bracket bolts.
-
Bracket Arm Adjustment: - Adjust the angle of the bracket arm to the desired position and tighten nuts.
-
Post Adjustment: - Additional leveling may be required.
-
Tighten All Bolts: - Once everything is aligned and adjusted, tighten all bolts and nuts securely.
​
By following these instructions, you will ensure a proper and secure installation of the Grab Rail Anchor Bracket.